Hello. After a recent upgrade of my internet connection my openvpn/portmap won’t connect anymore. it would connect if i use it with another vpn software, but now that “trick” doesn’t work anymore. Sat Apr 18 03:22:33 2020 OpenVPN 2.4.8 x86_64-w64-mingw32 [SSL (OpenSSL)] [LZO] [LZ4] [PKCS11] [AEAD]…

[image] redz: ERROR: Windows route add command failed [adaptive]: returned error code 1 Please, reinstall the OpenVPN client.

it’s always mentioned by alexy when he suggest vpn’s w/ portforwarding. :slight_smile:

In that case he would be the one to be able to help you set it up :wink: or you could try searching their support documentation on the purevpn website.

I would like to suggest to remove the connection on portmap.io and re-create it again. It will give you another address and config, which you can use in your setup instead of old connection. Regarding port forwarding with PureVPN: https://support.purevpn.com/how-to-activate-port-forwarding-on-windo…

Did that in purevpn, still not working. Good news though as openvpn/portmap is working again. my node is still showing offline but i’ll wait for a couple of hours and update here. Thanks again alexey…

Still showing offline… i’m pretty sure everything is set-up correctly…

Perhaps not. Please, check that your portmap.io port is open: https://www.yougetsignal.com/tools/open-ports/ Specify your portmap.io address in the Remote address field and your portmap.io port in the Port Number, then click Check. If port is closed, make sure that your OpenVPN connection is estab…

It’s showing closed. could this be the problem? Sat Apr 18 20:58:15 2020 ROUTE: route addition failed using CreateIpForwardEntry: Access is denied. [status=5 if_index=20] Sat Apr 18 20:58:15 2020 env_block: add PATH=C:\WINDOWS\System32;C:\WINDOWS;C:\WINDOWS\System32\Wbem Sat Apr 18 20:58:15 202…

Got it! Working now… :slight_smile: Just found out there’s a new openvpn version… Thanks again Alexey!

okay, new question on this, and it’s related to no-ip and my router. To set up a second node here at home: Can I use the same hostname on No-IP? When setting up the port forwarding on my router, I can only denote a single DDNS provider and hostname as seen below: [image] So ultimately, my ques…

yes you can use the same no ip address for both because its routing the same public IP address.

Storj Community Forum (official)

PORT Forwarding problems

Node Operators troubleshooting

vpn, port-forwarding

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled