MrGeekk
November 28, 2019, 10:04pm
1
I just created my code and it stays off!
Enzo
November 28, 2019, 10:37pm
2
Welcome to the the forum! @MrGeekk
Here are a list of things you can try.
Make sure:
~You are properly port forwarded.
Also, you can post photos directly on the forum!
Alexey
November 28, 2019, 10:46pm
3
Hello @MrGeekk ,
Please, go through this checklist:
It should connect in seconds. There are a few things you should check.
Start with checking the port. On https://www.yougetsignal.com/tools/open-ports/?port=28967 you can fill in the domain or IP you are using in the run command. Then check the port.
If it’s closed, it could still be several things.
Make sure the WAN IP you see in your router settings matches the IP shown on the above page.
Make sure your port forward is set up correctly. That means no filter on incoming IPs, forwarding to th…
MrGeekk
November 29, 2019, 7:05am
4
Problème réglée . J’avais juste mal renseigner l’ip de “NO-IP” je l’ai modifier est tout est revenue dans l’ordre .
Merci
