Storj node on a synology docker

[daschmidt]

Good evening,

i can’t bring up my node on my Synology.

I used this
tutorial and the official cli installation from the storj homepage.

The docker and the webgui start but i get this error:

The logs

The port is also correct forwarded.

Sorry for my bad english.

With best regards daschmidt

[Alexey]

Hello @daschmidt ,
Welcome to the forum!

"ping satellite error: failed to dial storage node (ID: 12P8c8wQbePV8TGH8ifqPscrScLfKv3tqTGHzZNUwPDtnHaLow9) at address xxxxxx28967: rpc: dial tcp xxxxx:28967: i/o timeout

Your node is not reachable.
Please use this checklist:

My Node is OFFLINE for 2 hours

It should connect in seconds. There are a few things you should check. Start with checking the port. On https://www.yougetsignal.com/tools/open-ports/?port=28967 you can fill in the domain or IP you are using in the run command. Then check the port. If it’s closed, it could still be several things. Make sure the WAN IP you see in your router settings matches the IP shown on the above page. Make sure your port forward is set up correctly. That means no filter on incoming IPs, forwarding to th…

[daschmidt]

thanks this was my bad the synology’s firewall blocked the port. I was locking for the mistake at the wrong place.

Now I only have this error: WARN contact:service Your node is still considered to be online but encountered an error.
But I see trafic.

[Alexey]

@daschmidt

WARN contact:service Your node is still considered to be online but encountered an error.

This WARN explained there:

@Stob

Breaking down the errors:

WARN    contact:service Your node is still considered to be online but encountered an error.    {"Satellite ID": "121RTSDpyNZVcEU84Ticf2L1ntiuUimbWgfATz21tuvgk3vzoA6", "Error": "contact: failed to dial storage node (ID: 1XtserY2gWe4q8TafVMsa5bLSnZcncY4EDMqBagqpYigRy4FEF) at address carovonoliver-49838.portmap.host:49838 using QUIC: rpc: quic error: Timeout: No recent network activity

These relate to UDP port forwarding testing - Experimenting with UDP based protocols . There’s no need to ‘fix’ yet as this is just for testing but may be requested in the future.